Wheel Pressing Tools
Wheel Spacer Gauges
- Designed for older Lionel Standard, O, O27-Gauge & American Flyer S-Gauge engines. May work on others
- The tool is machined out of solid aluminum
- Place gauge between wheel when pressing them back on so you don’t OVER press the wheels back on.
- Will not work on engines where the drive gear on back of wheel is the same size as the wheel. Like many Marx’s Engines.
Standard Gauge Wheel Spacer: $23
O & O27 Gauge Wheel Spacer: $21
Will not work on Marx’s Engines.
S Gauge Wheel Spacer: $21
Axle Block - 2 sided: $32
- Wheel / Axel holding jig.
- Design for standard Diameter axle w/ & w/o countersinks used by Lionel, American Flyer, & Marx’s Engines. In Standard , O & S Gauges. But can be used for others.
- Block sits flat on the back of the wheel to hold axle at 90 degrees when press into wheel.
- Some wheels will needs to be used with the Wheel cups or our Quartering cups to hold them flat.
- Can be used in an Arbor Press.
- The tool is machined out of solid 3/4″ Aluminum.
- Block is 2 sided.
- Side 1: 0.15″, 0.165″, & 0.19″ straight & 0.135″ & 0.18 with countersink..
- Side 2: 0.135″, 0.15″, 0.18″, & 0.19″ straight & 0.165 with countersink
