Can Motor Tool Set

Can Motor Tool Set

• Design to take off Worm gears & Flywheels/Encoders of can motors found in Lionel & MTH modern model trains
• Can be use with Arbor Press
• Harden Pin smaller than the shaft dia.
• Holder can be used on the Pin.
• Holder can also be used for the motor when pressing Flywheel or gear back on.
• Flywheel/Encoder Plate & Shim.
• Shim for Flywheel that has a magnet & it hangs down. Do NOT press on the magnet, it will break easily. Use shim so you press on the brass part.
• Roll rubber piece & place in the clamp size you need. Then slide the gear into the clamp. Center the clamp on gear then tighten very, very tight. You may need to cut extra rubber off to see. Setup in press with pin & press gear off.
• Only need to tighten the 2 bolts
• Rubber pieces are used to protect worm gear from damage in the clamping. Also provides more grip.
• Rubber pieces will wear & can be easily replace with a bicycle tire tube.