Armature Pinion Puller & Press Set - Ver 2

image53

- This tool was designed to pull & replace stripped or worn out pinion gears on the armature used in many Lionel Trains. 

- Can be used in an Arbor Press.

- The tool is machined out of solid aluminum Shaft Block & Pinion Press, Steel Crossbar & Lower Jaws

- Shaft Block has (3) 1/8" hole at 3/16", 3/8" & 1/2" depths. Used for holding shaft at 90 when pressing pinion gear on w/o pressing on the commutator. Also when pressing in a new shaft, it will fully support the commutator.

- See drawing for max gear sizes

image54

Kit includes

  • Pinion Puller
  • Shaft block (Updated)
  • Pinion Press
  • Lower Jaw for small Pinions
  • Lower Jaw for large Pinion (New)

Armature Press Cup Set - Ver 2

image55

  

- Can be use with Arbor Press

- Used to press out shaft or Worm drives from armature.


Kit includes:

Cup 1 for 1" & 1-1/4" Armatures

Cup 2 for 1-1/8" Armatures (New)

3/32" X 1" Hardened Pin (New)

Brushes Installation Plate

image62

This installation tool is to hold the brush in the brush plate as you install it. Then slide out the plate & Screw holder in place.

Like what you see. Tools are available on thur Ebay now. Click link below.

Ebay link
image63

Armature Examples used in Armature cups & Pinion Pullers

  

1. 1" O.D. - from a 2034 Steam Engine

2. 1" O.D. - from a 3927 Track Cleaning Car

3. 1-1/4" O.D. - from a Pre-War 248 Electric Engine

4. 1-1/4" O.D. - from a 2025 Steam Engine

5. 1-1/8" O.D. - from a 671 Steam Turbine Engine

6. 1-1/8" O.D. - from a 1981 Burger King 8160 Diesel Engine